pcmcia-cs doesn't use the same modules as normal network cards do. What I'd do is get the newest version of pcmcia-cs http://pcmcia-cs.sourceforge.net/ and compile/install it yourself. David Hinds has done an awesome job of setting up PCMCIA drivers for linux. Read the PCMCIA-HOWTO file that comes with pcmcia-cs. I wish all machines had pcmcia slots. It's awesome being able to take out one card, plop in another and not even fall off the network. In my experience with NT you had to install drivers each time you put a new card in, even if it was just in the other slot. Tim On Tue, Oct 10, 2000 at 02:38:05PM -0500, Perry Hoekstra wrote: > The Ixian wrote: > > > > did you, by chance, compile your kernel with eepro support? > > No, I have not touched the kernel > > > if you have compiled the driver as a module you need to load it first > > (remember to unload your current driver, if applicable) > > once it is loaded run ifconfig and set your default gateway and you are > > ready to go. > > The module eepro100 exists in the modules directory. I did an insmod on > the module and saw it loaded through lsmod and there is no modules > dependencies within modules.dep. There is not a current network driver > loaded because it was coming through the PCMCIA card. I would like to > have the module loaded automatically. Does anyone know within Debian > what the appropriate rc script is to issue an insmod? > > -- > Perry Hoekstra > E-Commerce Architect > Talent Software Services > dutchman at mn.uswest.net > > --------------------------------------------------------------------- > To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org > For additional commands, e-mail: tclug-list-help at mn-linux.org --------------------------------------------------------------------- To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org For additional commands, e-mail: tclug-list-help at mn-linux.org