Yaron wrote: > > Hi, > > On Wed, 11 Oct 2000, Adam Maloney wrote: > > > So basically my question is, how do I configure X now? I want 1280x1024, > > maybe 1600x1200 (depends on how tiny that gets...). > > Well, uh, did you get X fully downgraded back to 3.*? If so, does > xf86config still not work? > > On another note, there's really no reason for X4.0+ not to work, and > definetly none for it to have LESS support for your card than 3.3.6. I > would give it another try. > > Since xf86config won't really generate really hires configs, try using a > program like kvidiogen which will generate modelines you can stick in > XF86Config. I've got X4.01 running on my work machine with a Mach64-based Rage Pro. Sadly, it appears that the driver for that card is *weak*, to say the least. Not only will it not do OpenGL acceleration properly (Q3A demo runs at ~1.5seconds/frame), but when I set my default resolution to 1600x1200, I get a 'resolution not supported by driver' crash-error. No good. -- <------------------------Chris H. Bidler, Internet Helper Monkey-------------------------> The drive banged 3-4 times the head against its endrun, maybe to BE SURE it was there ... "*Beep TAka TAka TAka TAka -whirr- ..." -- simulated persona = "The Cube", node #251, of http://www.forum2000.org --------------------------------------------------------------------- To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org For additional commands, e-mail: tclug-list-help at mn-linux.org