I picked up a Dell Latitude XPi P133ST a while back, and I've installed Linux on it. I've got everything going except the sound on it. Dell's webpage (http://support.dell.com/docs/DTA/_titan/00000001.htm#P133ST) lists it as: SoundBlasterPro Compatible 3.01 vboice and music functions ES1888 ISA bus IRQ 5 (capture IRQ) 9 (playback IRQ) DMA 0 (capture DMA) 2 (playback DMA) I/O 0x220-22F (configuration registers) I/O 0x288-28B (FM synthesizer) I/O 0x330-331 (MPU 401) Based on the kernel docs, the SoundBlaster module should be able to do it. I've been using: /sbin/modprobe sb io=0x220 irq=5 dma=0 dma16=5 mpu_io=0x330 (insert just about every combination of the above IRQs, DMAs, and I/O addresses I could think of) It consistently comes up as 'device or resource busy'. I checked /proc/interrupts, /proc/ioports, and /proc/dma and none of the requisite resources are busy. Configuring it in the kernel instead of as a module doesn't result in any direct errors, but results in 'No such device' any time I try to send something to /dev/audio, and /dev/sndstat shows stuff under Installed Drivers and Card Config (everything here is in parentheses), but nothing under Audio, Synth, or Midi devices. Anyone else tried setting up sound on one of these that could give me a hint? Michael Vieths Foeclan at Winternet.Com --------------------------------------------------------------------- To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org For additional commands, e-mail: tclug-list-help at mn-linux.org