You did. I didn't see the speed increase right away. When I did, a couple of days later, I had wondered if you had perhaps "upgraded" to postfix :) Tom Veldhouse veldy at veldy.net ----- Original Message ----- From: "Bob Tanner" <tanner at real-time.com> To: <tclug-list at mn-linux.org> Sent: Saturday, April 21, 2001 3:20 PM Subject: Re: [TCLUG] Mailman & sendmail? > Quoting Thomas T. Veldhouse (veldy at veldy.net): > > Is the tclug-list at mn-linux.org list using sendmail still? I noticed that > > mails are being sent to the list in nearly real-time now. Is this because > > of the changes mad to the sendmail configuration or is it using postfix now > > :) ? > > Changes to sendmail. > > I thought for sure I posted the changes. :-( > > Here they are again. > > First make sure you DO NOT have FEATURE(`relay_based_on_MX'), that was the > single most important factor. See your README.cf for what this does. > > Here are my tweaks for timeouts: > > define(`confTO_INITIAL', `2m')dnl > define(`confTO_CONNECT', `2m')dnl > define(`confTO_ICONNECT', `2m')dnl > define(`confTO_HELO', `2m')dnl > define(`confTO_RCPT', `2m')dnl > define(`confTO_QUEUERETURN', `1h')dnl > define(`confTO_QUEUEWARN', `30m')dnl > > To REALLY get a performance boast I enabled 20 queues: > > define(QUEUE_DIR,`/var/spool/mqueue/q*') > > See sendmail.net for a great article on this. > > Here is my mm_cfg.py > > # Ceiling on the number of recipients that can be specified in a single SMTP > # transaction. Set to 0 to submit the entire recipient list in one > # transaction. Only used with the SMTPDirect DELIVERY_MODULE. > SMTP_MAX_RCPTS = 50 > > # Two other qrunner resource management variables. The first controls the > # maximum lifetime of any single qrunner process, and the second controls the > # maximum number of messages a single qrunner process will, er, process. > # Exceeding either limit causes qrunner to exit, reclaiming system resources > # and deleting the lock. Other qrunners will then process the remaining > # messages. Set either to None to inhibit this resource check. > QRUNNER_PROCESS_LIFETIME = minutes(30) > QRUNNER_MAX_MESSAGES = 300 > > -- > Bob Tanner <tanner at real-time.com> | Phone : (952)943-8700 > http://www.mn-linux.org | Fax : (952)943-8500 > Key fingerprint = 6C E9 51 4F D5 3E 4C 66 62 A9 10 E5 35 85 39 D9 > > _______________________________________________ > tclug-list mailing list > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list >