The 3Crap cable modem is 10/half only. Therefore your connection to a swtich will be 10/half for that "segment". Collisons will occur between the swtich and cable modem even with just two hosts just due to the nature of ethernet. Unless you are seeing more than 1-2% of total packest repored as collisons then you most likely dont have a collision problem. If you are on a hub then you will see even more. If you have a hardware problem you pings between you boxes (assuming you have two or more) will show high latency occasionally (>20ms). Most "donald becker" drivers can be recompiled with more debug info. in your .c code up DEBUG to 3 or 4 and recompile. Usualy you will get speed/deplux setting info with higer debug info. On Wed, 7 Mar 2001, Chuck Larson wrote: > Hi all, > > Sorry I missed the install fest on saturday; I had a fever of 100.6. > > So, I have a cable modem (through roadrunner) and I am getting a high rate of collisions. I was looking through the specs on the modem and noticed it is half-duplex. Is there anyway to set/check the half-duplex status on the NIC on my linux router. > > _____________________________________________________________ > Domain powered by www.iReg.com > E-mail powered by www.1FreeEmail.com > _______________________________________________ > tclug-list mailing list > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list >