We are running 5.0Ai13 on Max4004, I have downloaded the 6.0b code (tik.m40) and the release note for it and I am planning to upgrade it. Since we have a bad experience when we upgraded the code to support K56 modem modules (that unit ended up RMAed), I am very cautious this time. I have gone through the note and it mentioned something about "thin load" and "fat load" but it did not mention whether I need "thin" or "fat" for the current software version for my Max. So, can I just upload the 6.0b code by going to the debug mode and do a "tloadcode" and "nvr" ? or I need to download something first? Also, is this process reversible? ie. If something goes wrong, can I put the 5.0Ai13 back on ? Thanks Daniel P.S. whenever you upgrade your software, never do it on Thursday or Friday or else something goes wrong, you are stuck for the whole weekend. ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg11465.html">Re: (ASCEND) Re: Telco encroachment WAS Pipeline family andAlways On/DI?</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg11462.html">Re: (ASCEND) My Error: K56 boards rev. F</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg11463.html">(ASCEND) Equiv to modemdiag for TNT</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg11465.html">Re: (ASCEND) Re: Telco encroachment WAS Pipeline family andAlways On/DI?</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="maillist.html#11464"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd268.html#11464"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>