Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(ASCEND) Filters question
According to my manmual, the path to follow to set up a filter on a
P75 is:
Ethernet > Filters > _any_profile_ > Input Filters > 01 to 12 > Ip
If I go to Ethernet, one of my options is Filters. If I go to
Filters, I am supposed to see a list of profiles. According to the
manual, you apply the filter by specifying which profile it is in
from inside the connection profile. These are supposed to be whole
numbers. Thus, I should see a list of whole numbers when I go to
Ethernet > Filters. Instead, going to Ethernet > Filters produces:
20-400 Filters
20-401 IP Call
20-402 NetWare Call
20-403 AppleTalk Call
Well, I am trying to set up an IP filter, so I select IP Call.
This brings up
20-401 IP Call
Name=IP Call
Input filters...
Output filters...
This is what is supposed to show up after I select up a Profile number.
If I keep going, I complete setting up an IP filter that does something
really simple: it blocks ICMP traffic with a certain source address. If I
put this in slot 01 (this number being chosen two levels lower than the
manual says), and then set the Data Filter to '1' in my connection profile,
then I end up blocking ALL IP traffic, ICMP or otherwise.
What am I doing wrong???
--
"She's more a roller coaster, than Jack McKinney
the train I used to know." jackmc@realtime.net
-Grateful Dead Real/Time Communications (459-0604)
Programmer/System Administrator
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.shore.net/~dreaming/ascend-faq>
or <ftp://ftp.shore.net/members/dreaming/ascend-faq.txt>