Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(ASCEND) P75 pots problem
Hello,
I have a P75 which has been in service for several months on a bri
provisioned as recomended by Ascend to allow an incomming pots call
to interrupt a B channel if a 128k connection is up.
This has worked perfectly since installation...until now.
Suddenly, the unit does not see ANY incomming calls...whether or not
a data call is up. I can dial out with no problems....with
either a data or a pots call on either channel. But, again, it will
not show an incomming call!
I have put a USR I-modem on the bri and it works fine...that is, it
will see and actually ring a phone when called.
The caller just hears a ring as normal. Even when I bring up a B
channel to two separate locations, the caller hears a ring. NOT
a busy signal, as they should (which until now has been the case).
The phone company swears by not having changed anything in the
provisioning,(BellSouth territory).
Does this sound like a hardware problem? I have tried software
from 4.6C - 5.0Ap10 with the same results. (Has previously been
working on 5.0A).
It acts like hardware, but I'm perplexed that outgoing calls
work without a hitch on both data and pots.
Any ideas?
Thanks,
JIM
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.shore.net/~dreaming/ascend-faq>
or <ftp://ftp.shore.net/members/dreaming/ascend-faq.txt>
Follow-Ups: