I reboot the MAX, enter the TermSrv and do a "show ip route" and it displays
a full table. I exit, I do a Upd Rem Cfg (any of the 5 options works) and
my routing table is reduced to a couple of standard bits and current users.
I first noticed it on p7, downgraded to p4 and it still happens. Has this
been raised before? I'm using the eb.m40 load.
Any feedback appreciated,
Aron
--
Aron Bibby ************** Tel : +44 (0)117 922 9604
Computer Network Services **** *****
Hewlett-Packard Laboratories ** /_ __ ***
Filton Road * / / /_/ ** Fax : +44 (0)117 922 9742
Stoke Gifford ** / *** Alt. : +44 (0)117 922 8924
Bristol BS12 6QZ **** ***** EMail: ab@hplb.hpl.hp.com
England ************** aron@bibby.hpl.hp.com
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <<A HREF="http://www.shore.net/~dreaming/ascend-faq">http://www.shore.net/~dreaming/ascend-faq</A>>
or <<A HREF="ftp://ftp.shore.net/members/dreaming/ascend-faq.txt">ftp://ftp.shore.net/members/dreaming/ascend-faq.txt</A>>
</PRE>
<!--X-MsgBody-End-->
<!--X-Follow-Ups-->
<!--X-Follow-Ups-End-->
<!--X-References-->
<!--X-References-End-->
<!--X-BotPNI-->
<HR>
<UL>
<LI>Prev by Date:
<STRONG><A HREF="msg00800.html">(ASCEND) USR 28.8 problems?</A></STRONG>
</LI>
<LI>Next by Date:
<STRONG><A HREF="msg00797.html">(ASCEND) NAT Configuring the Pipeline to use a single IP address</A></STRONG>
</LI>
<LI>Prev by thread:
<STRONG><A HREF="msg00797.html">(ASCEND) NAT Configuring the Pipeline to use a single IP address</A></STRONG>
</LI>
<LI>Next by thread:
<STRONG><A HREF="msg00800.html">(ASCEND) USR 28.8 problems?</A></STRONG>
</LI>
<LI>Index(es):
<UL>
<LI><A HREF="maillist.html#00799"><STRONG>Main</STRONG></A></LI>
<LI><A HREF="thrd31.html#00799"><STRONG>Thread</STRONG></A></LI>
</UL>
</LI>
</UL>
<!--X-BotPNI-End-->
<!--X-User-Footer-->
<!--X-User-Footer-End-->
</BODY>
</HTML>