Re: Re[2]: (ASCEND) Fw: Cisco / MAX4000 callback ?

[Elmar Haag <haag@centaur.de>]

On Wed, 21 May 1997, Pierre-Yves Kerembellec wrote:

> >  You cannot try it for a RADIUS profile. Do this: create a MAX connection 
> >  profile , Name="test", Dial="014612XXXX", enable IP routing and the hole 
> >  stuff involved with it. Save the profile. Enter the profile again. Press 
> >  Ctrl-D so you get the DO menu. In actual releases (5.0Ap7 for example) 
> >  you get a menu entr "2...dial". So press 2 and watch the log. It should read:
> >  "Ougoing call to 014612xxxx. ... Connected, assigned to port bla bla bla. 
> >  LAN session up, test".
> 
> It does not work ... I never get the '2...dial' prompt ...

It think THAT is the main problem you should further investigate in!

> 
> >  > NB: I cannot use CLID authentication since the Cisco won't
> >  > validate callback until fully authenticated wia PAP or CHAP
> >  > to the other end ...
> >  So does the MAX. It hangs up and calls back not before the LAN session is UP!
> 
> ... and if the LAN session is UP, LCP and IPCP are negociated right ?
> 
AFAIK yes.


Greetings,

Elmar
----------------------------------------------------------------------
Elmar Haag             CENTAUR COMMUNICATION           Urbanstrasse 68
haag@centaur.de         Xlink PoP Heilbronn            74074 Heilbronn
http://www.centaur.de   Tel +49 7131 799 258     Fax +49 7131 799 260



++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.shore.net/~dreaming/ascend-faq>
or		<ftp://ftp.shore.net/members/dreaming/ascend-faq.txt>

---

References:

• Re[2]: (ASCEND) Fw: Cisco / MAX4000 callback ?
• From: Pierre-Yves Kerembellec <Pierre-Yves.Kerembellec@vtcom.fr>

---

• Prev by Date: (ASCEND) Problem with a P75 not dialing out.
• Next by Date: (ASCEND) Channelized T1 using MF Signaling
• Next by thread: Re: (ASCEND) 5.0Ai10
• Index(es):
  • Main
  • Thread