I'm working on this with Support, but thought maybe someone here has ideas or experience. Config: P400/T1/PRI/4.6Cp15 and P50/UBRI/5.0Ap5 Ascend free Radius 961029 on Solaris 2.4 in dbm mode. Dial up both ways on demand. If the P50 initiates the call, all is fine and the second channel is added and removed correctly. If the P400 initiates the call and the P50 profile is local to the P400 all is fine too. BUT, if the P400 gets the dialout profile from Radius and initiates the call, the connection goes dead immediately when the second channel is added. (On the P400 I see the utilization drop from 100% to 0% and stay there.) The call falls back to 1 channel at the appropriate time, but still no data passes until the connection is hung up and redialed. While the connection is not passing traffic, a "show ip route" on the P400 looks normal, but it sends icmp error "host unreachable - out of range" for all packets destined for the P50 network. I don't see why adding the second channel should affect routing or why Radius vs. local profile info should make a difference at that point. Any ideas or experience? ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.shore.net/~dreaming/ascend-faq">http://www.shore.net/~dreaming/ascend-faq</A>> or <<A HREF="ftp://ftp.shore.net/members/dreaming/ascend-faq.txt">ftp://ftp.shore.net/members/dreaming/ascend-faq.txt</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg00287.html">Re: (ASCEND) Disabling internal-NT1 on Ascend P50 UBRI</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg00284.html">Re: (ASCEND) MAX-->CISCO ISDN connexion</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg00297.html">Re: (ASCEND) Modem connection problems</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg00301.html">(ASCEND) Re: Disabling internal-NT1 on Ascend P50 UBRI</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="mail2.html#00285"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd12.html#00285"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>