Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: (ASCEND) NAT

Anyone using a RADIUS profiles for this, and if so what does the profile
look like?  And can you share how to set up the P75?  Just the pertinent
configuration attributes...

Kirk
 

		-----Original Message-----
		From:	kevin [mailto:kevin.b@flash.net]
		Sent:	Monday, August 17, 1998 8:13 PM
		To:	claudio@tasco.cl
		Cc:	ascend-users@bungi.com
		Subject:	Re: (ASCEND) NAT

		At 01:03 AM 8/18/98 , claudio@tasco.cl wrote:
		>Hi guys,
		>
		>
		>I need urgently your help with NAT and DHCP with a P50.

		>
		>What is the way to configure a P50 for NAT_
		>
		>NAT works fine for one or two PC's but whe you add more
the P50 goes 
		>crazy. The link is up but only some PS's are able to
route. (wich is
		>not always the same, much to my regret!)
		>
		>I might be doing something wrong.
		>
		>Should I use Single or Multiple IP
		>Proxy Mode= Always, Active or Off
		>Do I need a particular software load? 
		>

		Mult-IP requires a special setup on the ISP side.  go
with Single IP NAT.
		Proxy mode i don't think matters, mine is set on Always.
Use either 6.0.9
		or 6.1.5 software load, depending on how old your
pipeline is.
		---
		kevin

		ISDN/Commercial Support Dept
kevin.b@flash.net
		Flashnet Communications                         [Quake
is law]
		++ Ascend Users Mailing List ++
		To unsubscribe:	send unsubscribe to
ascend-users-request@bungi.com
		To get FAQ'd:	<http://www.nealis.net/ascend/faq>
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>
Follow-Ups: