Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Static IP Users
At 19:32 25/08/98 -0700, Laurent Saehyun Kim wrote:
>I have both Pool-Only = Yes and Proxy Mode = Active and it still does not
>work. Here is an interesting thing though.
>
>Our Router Address XXX.XXX.XXX.1
>Max4004 XXX.XXX.XXX.10
>Max6000 XXX.XXX.XXX.130
>
>If I assign a user with static IP such as XXX.XXX.XXX.1, it works fine
>without any problem when dialed to Max4004 or Max6000 (Note that the
>static IP is on the same Class C network)
>
>If I assign a user with static IP from another Class C YYY.YYY.YYY.250, it
>does not work; however, if I set the static route from the router ( ip
>route YYY.YYY.YYY.0 255.255.255.0 XXX.XXX.XXX.10 ) it works but only to
>Max4004.
Sounds fair ;-)
>I have RIP turned off on both MAXs.
It _may_ be fixable/hackable with RIP, however...
>Any idea?
Can you configure your router's ethernet interface with a secondary address
in the YYY.YYY.YYY.___ network? The point is that you will then have a
route to that network pointing down the correct interface of your router, in
combination with Proxy-ARP it shouldn't matter which MAX they dial into :-)))
HTH,
Neale.
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups: