RE: (ASCEND) Disconnect Code 240?

[Mike Neagle <mneag@host.ka.net>]

I'm only getting it on analog calls.

On Wed, 1 Jul 1998, Danko Jevtovic wrote:

> 
> > I just installed 6.1.3 on a 4048 yesterday to test the V.90 once again.
> > It doesn't seem to running out of IP numbers (yet), but I've had about 100
> > or so disconnects with Cause Code 240.  None of my DCC matricies go above
> =============================================
> Same problem, same code (240), can not find any info.  I suspect that we
> have some problem with MP on ISDN dual-channel calls when both call fall
> on same MAX (we have two 4030 each with one PRI-E1).
> 
> 
> 

+----------------------------------------------------------------------+
| Mike Neagle              Systems Engineer            mneag@KA.net    |
|       KA.net Services / 2108 Plantside Drive / Louisville, KY  40299 |
+----------------------------------------------------------------------+

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

References:

• RE: (ASCEND) Disconnect Code 240?
• From: "Danko Jevtovic" <danko@sezampro.yu>

---

• Prev by Date: Re: (ASCEND) Radius (fwd)
• Next by Date: Re: (ASCEND) Radius (fwd)
• Prev by thread: RE: (ASCEND) Disconnect Code 240?
• Next by thread: (ASCEND) Configuring Pipe75 using NAT
• Index(es):
  • Main
  • Thread