Re: (ASCEND) PRI does not fill up after reboot

[Peter McDermott <peter@petermc.demon.co.uk>]

>The story that we received from Ascend in Australia was that the E1 load of
>code was not sending disconnect/connect information to the switch on warm
>boots.  If you did a cold boot, the channels would come back.  This was
>found in version 6.1.7, & supposedly fixed in 6.1.24 (wasn't in the end).
>No issues (like this) have been seen by us in any version 7 load.

Ah yes. I got caught out by this one. I'd initially misconfigured
my lines to the extent that it caused some sort of busy-out at
the telco end.

Even after I reconfigured it correctly, I was still getting the
horrible voice message when I tried to dial in. "This line is
temporarily out of order - please try again later." (At least,
I'm assuming it was the telco that was sending this out. It
couldn't have been the Ascend could it?)

Anyway, frustrated and angry, I turn off the machine and decide
to call support on Monday morning. Whereupon the guy on the desk
immediately manages to dial in without any problem at all. I'd
done umpteen soft resets, but they hadn't had any impact at all.
The hard reset had obviously sorted it out.

P.


++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>