Re: [TCLUG:10371] SMP and Adaptec 2940

[Peter Lukas <peter@math.umn.edu>]

Probably a tad late, but you are terminated and using the appropriate ID's
in the chain?  Have you compiled direct 2940 support into your kernel?
have you tried booting with the 7880.i floppy for Slakware 7?  Did you
build the 7880 driver as a module (if so, did you make an initial ramdisk
to load the image from)?  Have you tried compiling the kernel with
SMP+2940 support?  How long did you specify the SCSI reset in your kernel
compilation?

Peter Lukas

On Mon, 22 Nov 1999, Jon Schewe wrote:

> On Mon, 22 Nov 1999, Adam Maloney wrote:
> 
> > The board is a tyan S-1662 (440BX, I think) dual processor.  I'm using
> > Pentium Pro 200/256k with SY032 stepping.  The SCSI card is an adaptec
> > 2940U/W, and I'm using the aic7xxx driver in the kernel.
> 
> Try this, use the SMP kernel with only one processor and see what happens.
> Perhaps there's something with the board having a second processor.  
> 
> -- 
> Jon Schewe 
> http://eggplant.mtu.net/~jpschewe
> schewe@tcfreenet.org
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: tclug-list-unsubscribe@mn-linux.org
> For additional commands, e-mail: tclug-list-help@mn-linux.org
> 
>