Re: (ASCEND) how to busy out channels

[Alex P <alex@stomp.gomax.com>]

If it's the card in the first modem slot that goes, make sure you tell the
MAX to start looking for modems in the new location in the same place as
below.

Alex P

On Sun, 7 Dec 1997, Leon McCalla wrote:

> net/t1 --> line config  --> factory -->  line 1
> 
> scroll down to a chanell then set it from switched to unused.
> 
> Leon McCalla
>   
> -----Original Message-----
> 
> >I recently had a modem card in one of my Max4000 units go
> >south (I'm running 5.0Ap36).  I run PRIs into this box
> >for mostly analog traffic.  Needless to say, it screwed
> >up my hunt group since there were only 40 modems available
> >but 48 lines going into the box.
> >
> >Is there a way to put a channel 'out of service' or have
> >the MAX do something to indicate the remaining 8 lines
> >cannot be used and to continue hunting on the next set of
> >lines?
> 
> ++ Ascend Users Mailing List ++
> To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd:	<http://www.nealis.net/ascend/faq>
> 

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

References:

• Re: (ASCEND) how to busy out channels
• From: "Leon McCalla" <ascend@caribbeanlink.com>

---

• Prev by Date: (ASCEND) Neat, huh?
• Next by Date: Re: (ASCEND) Max 5.0Ap36
• Prev by thread: Re: (ASCEND) how to busy out channels
• Next by thread: (ASCEND) does anyone have problems with 5 app 36?
• Index(es):
  • Main
  • Thread