Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Pipeline 5.1A with firewall
been there... done that..
you are probably using an older p50 and it is low on memory.
1) set all your filter profiles back to 0 temporarily then hang up any
connections to reset them.
2) delete 2 of your 3 firewall profiles.
if you can't delete the profiles goto system diag, restore config and
paste the following.. pressing ctrl-c after that will restore controll
START=FWALL=200=1
END=FWALL=200=1
START=FWALL=200=2
END=FWALL=200=2
3) fclear,fsave, nv to rebuild your config.
4) go back to business as usuall except DONT update a firewall while it is
active. If you have to do the following:
a) save to a new firewall
b) switch the connection profile to use the new firewall then hang up for it
to take effect on the next call.
c) goto the firewall menu and delete the older of the two profiles by saving
the blank one over its place.
Leon McCalla
-----Original Message-----
>Product: Ascend Pipeline 50 delivered with 5.1A and with firewall feature
>enabled.
>
>Problem: With the firewall turned on, after the router works as it should
for
>a few minutes the router starts to spontaneously reboot. Router works as
it
>should when being used with the firewall turned off (Session Options / Data
>Filter = 0).
>
>Is this a known problem with the firewall feature of 5.1A for pipelines?
If
>so, does one of the available patches (5.1Ap1, 5.1Ap2, 5.1Ap4, 5.1Ap6) fix
this problem?
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>