scroll down to a chanell then set it from switched to unused. Leon McCalla -----Original Message----- >I recently had a modem card in one of my Max4000 units go >south (I'm running 5.0Ap36). I run PRIs into this box >for mostly analog traffic. Needless to say, it screwed >up my hunt group since there were only 40 modems available >but 48 lines going into the box. > >Is there a way to put a channel 'out of service' or have >the MAX do something to indicate the remaining 8 lines >cannot be used and to continue hunting on the next set of >lines? ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <HR> <STRONG>Follow-Ups</STRONG>: <UL> <LI><STRONG><A HREF="msg11489.html">Re: (ASCEND) how to busy out channels</A></STRONG></LI> <UL> <LI><EM>From</EM>: Alex P <alex@stomp.gomax.com></LI> </UL> </UL> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg11480.html">Re: (ASCEND) Re: SNMP Interface representation</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg11478.html">Re: (ASCEND) ISDN Sig Not Inst</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg11475.html">(ASCEND) how to busy out channels</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg11489.html">Re: (ASCEND) how to busy out channels</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="maillist.html#11479"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd269.html#11479"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>