you are probably using an older p50 and it is low on memory. 1) set all your filter profiles back to 0 temporarily then hang up any connections to reset them. 2) delete 2 of your 3 firewall profiles. if you can't delete the profiles goto system diag, restore config and paste the following.. pressing ctrl-c after that will restore controll START=FWALL=200=1 END=FWALL=200=1 START=FWALL=200=2 END=FWALL=200=2 3) fclear,fsave, nv to rebuild your config. 4) go back to business as usuall except DONT update a firewall while it is active. If you have to do the following: a) save to a new firewall b) switch the connection profile to use the new firewall then hang up for it to take effect on the next call. c) goto the firewall menu and delete the older of the two profiles by saving the blank one over its place. Leon McCalla -----Original Message----- >Product: Ascend Pipeline 50 delivered with 5.1A and with firewall feature >enabled. > >Problem: With the firewall turned on, after the router works as it should for >a few minutes the router starts to spontaneously reboot. Router works as it >should when being used with the firewall turned off (Session Options / Data >Filter = 0). > >Is this a known problem with the firewall feature of 5.1A for pipelines? If >so, does one of the available patches (5.1Ap1, 5.1Ap2, 5.1Ap4, 5.1Ap6) fix this problem? ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg11766.html">Re: (ASCEND) 5.0Ap38 for the MAX products</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg11764.html">(ASCEND) max 2000 - calls get connected over disabled PRI</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg11755.html">(ASCEND) Pipeline 5.1A with firewall</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg11762.html">(ASCEND) Ascend Max - For Sale Question</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="maillist.html#11765"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd280.html#11765"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>