I have used the Gandalf 5242i but only connect back to 5342i not PM3. However, in the configuration for 5242i, you can specify wheather it connects to the same type (5242i) or not. To be exact, it will ask: "Peer is an equivalent spoofing brouter" and I believe your client should have no check mark on it. Also, on the "Authentication Protocol", I believe your client should use PAP not CHAP. Hope it helps.. Daniel >================================================================ >Sean H. Murphy <smurphy@yesic.com> >Yes IC Communications Inc. <<A HREF="http://www.yesic.com">http://www.yesic.com</A>> <<A HREF="http://support.yesic.com">http://support.yesic.com</A>> > > >- >To unsubscribe, email 'majordomo@livingston.com' with >'unsubscribe portmaster-users' in the body of the message. > > ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg12008.html">Re: (ASCEND) Radius Attribute</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg12006.html">(ASCEND) two seperate 64K connections to a Pipe50?</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg12006.html">(ASCEND) two seperate 64K connections to a Pipe50?</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg12011.html">(ASCEND) Multiple Profiles</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="maillist.html#12007"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd290.html#12007"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>