Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Two default routes?
Jim Howard wrote:
>
> At 14:25 10/06/1997 +0100, Rui Bastos wrote:
> >IGRP and both can reach my subnet. If the leased line fails all the
> >trafic from the internet goes to the ISDN connection.
>
> >Then I set up a default route... ok it is for cisco1.
> >After that tried to setup another deafault route to the cisco2 with a
> >lower preference.. but I always get the "Station/Gateway address
> >mismatch".
>
> you can't have more than one 0.0.0.0/0 static route,
> however you CAN put in a 1.0.0.0/0 which is equivalent
> and when properly weighted will become the default
> once the leased line goes down...
Hmm... I did some testing with another Max4000 ....this is not the
same scenario but the problem is the same.
I set a Max with no WAN connections and only a default route to a
Pipeline 50 on the ethernet. For tests I used some other pipelines ...
STATIC ROUTES
4** Default 0.0.0.0/0 to pipeline1 on the ethernet
401 aaa 1.0.0.0/0 to pipeline2 on the ethernet
402 bbb 1.0.0.0/0 to pipeline3 on the ethernet
403 bbb 1.0.0.0/0 to pipeline4 on the ethernet
even playing with the metrics and preferences, with 2.0.0.0/0 instead
of 1.0.0.0,etc swapping the order of the entries, making some private,
etc... the Max would only get the last entry, ie, iproute show only
showed the last entry. If I iproute del it I hadn't any default route
available :((((((
Is there a way of making a Max know that there are two deafult routes
without running any routing protocol? And of course without having to
entry it by iproute add....
Thanks in advance,
--
Rui Bastos (rdb@pintobasto.pt)
Pinto Basto Electrotecnia e Maquinas
Tel: +351 1 3972041 Fax: +351 1 3972595
http://www.pintobasto.pt
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: