An update: >>>> When Pacbell first set up CLID for two of our 5ESS lines, we did not get time and date. After I had Pacbell check the CLID lines, I now get time and date in the setup message. This would imply that the telco must enable time and date when enabling CLID. If we do not get the time and date, we will send out zero's in those fields. Also, there is one more limitation on the current implentation of the CLID: CLID is not supported when EKTS=Yes. <<<< Also, we need to get a bridisplay of the setup message to determine if we are getting time and date. Kevin ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <HR> <STRONG>Follow-Ups</STRONG>: <UL> <LI><STRONG><A HREF="msg09278.html">Re: (ASCEND) caller-id on POTS port of new P75</A></STRONG></LI> <UL> <LI><EM>From</EM>: David Lesher <wb8foz@nrk.com></LI> </UL> </UL> <!--X-Follow-Ups-End--> <!--X-References--> <STRONG>References</STRONG>: <UL> <LI><STRONG><A HREF="msg09262.html">RE: (ASCEND) caller-id on POTS port of new P75</A></STRONG></LI> <UL> <LI><EM>From</EM>: "Derek J. Stutsman" <dereks@dallas.net></LI> </UL> </UL> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg09286.html">Re: (ASCEND) caller-id on POTS port of new P75</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg09274.html">Re: (ASCEND) NavisAccess</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg09317.html">RE: (ASCEND) caller-id on POTS port of new P75</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg09278.html">Re: (ASCEND) caller-id on POTS port of new P75</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="mail30.html#09275"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd188.html#09275"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>