Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Nat setup help.
I'm not familiar with TNTs (just maxen and pipes), but can't you assign an IP
to the interface (or connection) on the TNT? Seems like there *must* be some
way for the TNT to assign an IP to the connection whether it's nailed or
whatever. Don't TNT's have connection profiles or are you using RADIUS?
Whatever your means of authenticating, that authentication *must* be able to
provide an IP (unless I'm wrong... which I doubt).
At 12:50 PM 8/2/98 -0500, Andy Walden wrote:
>> Whatever is on the other end of the T1 or ISDN - the device that the P130
>> "calls" to. It should assign an IP to the P130 when the connection is
>> established. The P130 will use that on it's wan interface and route out
>> through it as long as you have the P130 configured just like that Ascend
web
>> page says.
>
>One last thought then is the 130 is going over a nailed T1. Not switched.
>There is a way to make the TNT that is on the other end give the pipeline
>a real ip address? Then route to that IP address? I wish I could just
>route a real subnet, but in this case, this client needs it to appear
>there is only one ip address involved on his end.
>Thanks.
>
>-andy
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: