(ASCEND) Re: Max2000

[PFell@unmf.com (Peter Fell)]

     Forgive my ignorance but has anyone tried to setup dial-out over the 
     Lan via an Ascend box.
     
     Our box setup (2024 E1 bundle, one PRI line, 2 x 12 k56 boards, 
     5.0Ap36,eak.m20,Net 5 and 2DS)
     
     A single number is used to dial-in and this works fine.
     
     Basically the manuals say that if I enable Tserv and Immediate Modem + 
     Modem Dialout then I can Telnet into the box and issue modem AT 
     commands, ATDTxxxx where xxxx=Valid phone number etc.. to dial-out.
     
     The above works but I get a No Carrier message after the ATDTxxxx
     
     I'm really only doing the above to test whether Dial-out works with 
     the intention of installing MaxDial software on Win 3.X/Win95 PCs etc 
     to do the job.
     
     Any ideas would be appreciated regards dialing out.
     
     
     Thanks,
     
     
     
     Peter Fell (pfell@unmf.com)
     
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

• Prev by Date: RE: (ASCEND) Re: Max2000
• Next by Date: (ASCEND) Wanted: Used Max2012 or equivalent
• Prev by thread: (ASCEND) Wanted: Used Max2012 or equivalent
• Next by thread: RE: (ASCEND) Re: Max2000
• Index(es):
  • Main
  • Thread