Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) I'm having problems setting up my new MAX 4048
Thanks everyone for the info about the lights. Now when I call into the MAX
I get a busy signal with 0 sessions active and the call terminated window
logs the time of my last attempt. Now I know it's a configuration issue. Any
thought where I might have caused all me channels to be busy?
Randy Smith
-----Original Message-----
From: Randall Smith <forhire@lewiscounty.com>
To: ascend-users@bungi.com <ascend-users@bungi.com>
Date: Friday, August 28, 1998 11:31 PM
Subject: (ASCEND) I'm having problems setting up my new MAX 4048
>The telco finally hooked up our T1 this afternoon. I'm working my way
>through the quick start and I'm stuck. After I configure the T1 (Inband,
>AMI, D4, etc.) and I assign my numbers to the channels. It asks me "Is the
>Power LED on AND the fault, data, and alarm off? (page 3-13).
>
>My Power Light is ON (good).
>Fault Light is OFF (good).
>Data Light ON (BAD!, I think.).
>Alarm Light OFF (good).
>
>At this point the manual tells me to stop until I correct the problem and
>suggests a bad cable if it's a fault but doesn't mention where to look if
>it's the Data light. T1 termination looks good and no alarm light would
>lead me to believe the cable is good. What might cause the data light to
>stick on even when there are no active connections? I think it's something
>in my configuration. Or could it possibly still be a timing issue with my
>T1? Should I be calling Ascend or my phone company?
>
>Any Ideas would be a great help,
>
>Randy Smith
>
>++ Ascend Users Mailing List ++
>To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd: <http://www.nealis.net/ascend/faq>
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>