Re: (ASCEND) AMI Wink-Start configuration question (HELP)

["Steven T. Pierce" <stp@Dynasty.Net>]

Sounds like you are dealing with Bell South....

They did similar things on our CT1s (AMI / D4).... it had to do with the
number of digits they are sending....  they had to either do 7 or 0 to
get it to work, they were only doing 4.

Steven T. Pierce
stp@dynasty.net
Dynasty Online, Inc.
http://www.dynasty.net

"Nolan W. Bailey, Jr." wrote:

> Yesterday, we attempted to deploy several
> Ascend MAX 4048 to an area where the
> telephone switch only supports AMI encoding,
> D4 (its Super-Frame-- not ESF though) framing,
> Wink-Start... but, the phone company wasn't
> able to get the translations correct.
>
> Our MAX was showing a ring 'r', then 'c'...
> disconnect... over and over.... no calls would
> complete.
>
> My question... is that they were trying to
> send DP (dial-pulse) to our equipment,
> then... they tried "MF"... multi-frequency/fame?..
> that didn't make any difference... now, they
> want to reschedule the work... and try "DTMF"
> (regular touch tone).
>
> Anyone seen this before?  Please, please reply if
> you have any suggestions about this... anything
> they might have overlooked in the translations?
>
> Anything that we may have overlooked in our
> configuration?
>
> The phone technicians we were dealing were
> completely lost... they couldn't even figure out
> how to make a conference call while we working
> on this.... any help would be greatly appreciated.
>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd:   <http://www.nealis.net/ascend/faq>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>