(ASCEND) Secure Firewall

[Jeff Bronson <jeff@xpec.com>]

I have a PL75 and run the firewall.

Here is my trouble:

While I have blocked all telnet INTO the unit I would like to enable the
following:


I want ONE specific IP address to be able to telnet INTO my PL75
but nothing else.

I set this up and it doesnt work...

Do I need a static mapping after the hole in the firewall?

The IP address of the INcoming is 198.137.186.100 and the IP
address of the PL75 (on my lan) is 192.168.10.10

Any assistance would be appreciated!!!







________________________________________________________________________
        W E S T   A L L I S   M E M O R I A L   H O S P I T A L

Jeff Bronson
Aurora Health Care                Fax   : 414.328.8787
West Allis Wisconsin 53227        Office: 414.328.7575
Web ==> http://www.xpec.com       Email : jeff@xpec.com
________________________________________________________________________

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>