Re: (ASCEND) Secure Firewall

["Leon McCalla" <ascend@caribbeanlink.com>]

192.168.x.x is a private address range. Are you using NAT? or are you on a
completely private network. if you are using NAT you need to route port 23
to port 23 of the pipelines ethernet interface. on the firewall i'd only
allow one particular client to reace any telnet port on my LAN.

Leon McCalla

-----Original Message-----

>I have a PL75 and run the firewall.
>
>Here is my trouble:
>
>While I have blocked all telnet INTO the unit I would like to enable the
>following:
>
>
>I want ONE specific IP address to be able to telnet INTO my PL75
>but nothing else.
>
>I set this up and it doesnt work...
>
>Do I need a static mapping after the hole in the firewall?
>
>The IP address of the INcoming is 198.137.186.100 and the IP
>address of the PL75 (on my lan) is 192.168.10.10
>
>Any assistance would be appreciated!!!
>
>
>
>
>
>
>
>________________________________________________________________________
>        W E S T   A L L I S   M E M O R I A L   H O S P I T A L
>
>Jeff Bronson
>Aurora Health Care                Fax   : 414.328.8787
>West Allis Wisconsin 53227        Office: 414.328.7575
>Web ==> http://www.xpec.com       Email : jeff@xpec.com
>________________________________________________________________________
>
>++ Ascend Users Mailing List ++
>To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd: <http://www.nealis.net/ascend/faq>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>