RE: (ASCEND) p75 configuration

[Mike Groves <MikeG@polymerlabs.com>]

Hi Charles,

On BT ISDN lines the WAN light flashes for most of the time. After
disconnecting it stays off for about 10 seconds and then starts
flashing. That's normal!

What are you trying to connect to?

Does the test dial work? To do this go to Sys Diag | Term Serv and at
the ascend% prompt type 

test [your number]

If this does not work check your switch type in the configuration is it
set for UK?

If this does not work try a NET-3 switch type. -- I had to do this
recently after upgrading a Pipeline 50. The UK switch type did not work
whereas the NET-3 did (even though they are supposed to be the same!).

If this doesn't work we'll need some more information.

Cheers

Mike



-----Original Message-----
From: Charles Winston [mailto:mail@winston.prestel.co.uk]
Sent: 03 December 1998 11:30
To: ascend-users@max.bungi.com
Subject: (ASCEND) p75 configuration


I have just purchased an Ascend Pipeline 75 and Im having problems 
getting it to work 
correctly.

The software version is +6.1.0+

Firstly I cant get the WAN light to stop flashing although it is 
connected to the ISDN line.
VT100 connection shows X but changes to P if I dial the number.

I have followed all the instructions and setup the data as best I can.

I have only a Macintosh connected to the ethernet port via  a hub and
its 
set for TCP/IP
I have also got the same problems with only a PC connected.

Any advice from other users would be much appreciated.


Charles Winston


==============================

mail@winston.prestel.co.uk

TEL:  +44 141 571 9123
FAX:  +44 141 571 9124
ISDN: +44 141 571 0065


++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>