(ASCEND) DOV: 4048 call routing

[Joe Pautler <pautler@grasshopper.cit.buffalo.edu>]

givens:      we have a max4048, using one PRI (23B+D), with all modems
             disabled (in other words, it supports only ISDN users).
	     there is only one phone number used to dial into the
             PRI, and the last 4 digits are 5601.

the problem: we want to allow DOV (data over voice..tollmizer...etc)
             connections, in order to avoid ISDN data usage charges.
	     however, as of now, a voice (tollmizer, etc) call results
	     in a busy signal (presumably because the 4048 does not
	     have anything to route the call to).  if i enable one
	     of the modems, it will answer the call.  i currently
	     have Ethernet -> Mod Config -> WAN Options -> Ans 1#=5601.
	     changing that number to various other things (garbage)
	     results in no change of the behavior of either voice
	     or data calls.

my theory:   the provider of our PRI is not providing us with DNIS
	     information.  they "think" they are.

my question: are there any other parameters/settings, other than the
	     single one that i mentioned above, that i should 
 	     check/change?

thanks in advance for your time...

___________________________________________________________________________
Joe Pautler, E.I.T.                             University at Buffalo
CIT/OSS Network Engineering                     224 Computing Center
http://www.oss.buffalo.edu/~pautler             (716) 645-3536

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>