Re: (ASCEND) DOV: 4048 call routing

[Joe Pautler <pautler@grasshopper.cit.buffalo.edu>]

i was kind of surprised that i didn't get any replies to this
question.  however, i did some more research on my own, and it
seems that removing the modems completely has achieved the desired
effect.


Joe Pautler wrote:
]
]
]givens:      we have a max4048, using one PRI (23B+D), with all modems
]             disabled (in other words, it supports only ISDN users).
]	     there is only one phone number used to dial into the
]             PRI, and the last 4 digits are 5601.
]
]the problem: we want to allow DOV (data over voice..tollmizer...etc)
]             connections, in order to avoid ISDN data usage charges.
]	     however, as of now, a voice (tollmizer, etc) call results
]	     in a busy signal (presumably because the 4048 does not
]	     have anything to route the call to).  if i enable one
]	     of the modems, it will answer the call.  i currently
]	     have Ethernet -> Mod Config -> WAN Options -> Ans 1#=5601.
]	     changing that number to various other things (garbage)
]	     results in no change of the behavior of either voice
]	     or data calls.
]
]my theory:   the provider of our PRI is not providing us with DNIS
]	     information.  they "think" they are.
]
]my question: are there any other parameters/settings, other than the
]	     single one that i mentioned above, that i should 
] 	     check/change?
]
]thanks in advance for your time...

___________________________________________________________________________
Joe Pautler, E.I.T.                             University at Buffalo
CIT/OSS Network Engineering                     224 Computing Center
http://www.oss.buffalo.edu/~pautler             (716) 645-3536

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>