Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Multiple independent NFAS groups
At 09:48 AM 7/1/98 -0400, Jim Howard wrote:
>At 15:41 1998/06/30 -0400, Phillip Vandry wrote:
>>What about a TNT, now? What if we replaced a bunch of 4048's with a
>>single TNT. But each of the 4048's has NFAS across two lines. I want
>>to be sure it's possible to configure the distinction between 1 NFAS group
>>of 8 lines with 4 D channels, and 4 NFAS groups of 2 lines and 1 D channel
>>each.
>
>I have seen release notes for the TNT that state it can do this,
>and from what I can see on one of my 4000s, you can do it there too
>with something like this:
No, the MAX cannot "group" NFAS lines. If set to NFAS, the MAX assumes
all such T1s are in the same NFAS group. You can however have 1 NFAS and
2 PRI.
>10-000 Net/T1
>10-100 Line Config
> Line 1...
> Sig Mode=ISDN_NFAS
> NFAS ID num=1
> Ch 24=D-Channel
> Line 2...
> Sig Mode=ISDN_NFAS
> NFAS ID num=1
This would be invalid, as NFAS ID 1 is already assigned...
Kevin Smith Ascend Communications...
Customer Satisfaction ...where Network Solutions never end.
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: