Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) How to clear the flash of a P75?
Hi Folks,
What I did to my P50 6.0.0 is:
"fclear"
then
"nvram"
It comes back with blank configuration.
Regards,
Mike Chan
mike.chan@telus.com
----------
> From: Steve Camas <stevec@liii.com>
> To: Jim Howard <jhoward@lyceum.com>
> Cc: Brian Pavane <bpavane@liii.com>; Ascend Users Mailing List
<ascend-users@bungi.com>
> Subject: Re: (ASCEND) How to clear the flash of a P75?
> Date: Tuesday, July 28, 1998 11:01 AM
>
>
>
>
> On Tue, 28 Jul 1998, Jim Howard wrote:
>
> > At 19:10 1998/07/27 -0400, Brian Pavane wrote:
> > >I botched the code upload of an older P75 (Serial number of 714xxxx).
I
> >
> > >I do see the P6 Jumper, however it is just 3 pins. I try jumping any
two
> > >of them, and don't have luck with it booting up. In fact, the lights
on
> >
> > Are there jumpers at the front of the board, in between the LEDs?
> > If so, try P1...
> >
>
> Actually, P1 is off to the left of the LEDs but it did indeed do the
> trick. Brian thanks you and I thank you.
>
>
> Take care,
>
> Steve
>
>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups: