Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) How to clear the flash of a P75?
On Wed, 29 Jul 1998, mchan1 wrote:
> Hi Folks,
>
> What I did to my P50 6.0.0 is:
> "fclear"
> then
> "nvram"
I believe that should be "nvramclear"
> It comes back with blank configuration.
>
>
> Regards,
>
>
> Mike Chan
>
> mike.chan@telus.com
>
> ----------
> > From: Steve Camas <stevec@liii.com>
> > To: Jim Howard <jhoward@lyceum.com>
> > Cc: Brian Pavane <bpavane@liii.com>; Ascend Users Mailing List
> <ascend-users@bungi.com>
> > Subject: Re: (ASCEND) How to clear the flash of a P75?
> > Date: Tuesday, July 28, 1998 11:01 AM
> >
> >
> >
> >
> > On Tue, 28 Jul 1998, Jim Howard wrote:
> >
> > > At 19:10 1998/07/27 -0400, Brian Pavane wrote:
> > > >I botched the code upload of an older P75 (Serial number of 714xxxx).
> I
> > >
> > > >I do see the P6 Jumper, however it is just 3 pins. I try jumping any
> two
> > > >of them, and don't have luck with it booting up. In fact, the lights
> on
> > >
> > > Are there jumpers at the front of the board, in between the LEDs?
> > > If so, try P1...
> > >
> >
> > Actually, P1 is off to the left of the LEDs but it did indeed do the
> > trick. Brian thanks you and I thank you.
> >
> >
> > Take care,
> >
> > Steve
> >
> >
> > ++ Ascend Users Mailing List ++
> > To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> > To get FAQ'd: <http://www.nealis.net/ascend/faq>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>
/rf
Rich Fulton
Verio - East?
Engineering
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: