Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

(ASCEND) Pools and static IP on same Radius?

Hiya,

Up until now I've been running Radius[-971222] user profiles with static
IP mappings, but now have the requirement to have a default profile with
a small pool of addresses.

I configured the appropriate lines into my 'users' file -

pools-mymax  Password = "ascend", User-Service = Dialout-Framed-User
        Ascend-IP-Pool-Definition = "1 12.34.56.78 15"

DEFAULT Password = "ACE", Ascend-Token-Immediate = Tok-Imm-Yes
        Framed-Protocol = PPP,
        User-Service = Framed-User,
        Framed-Netmask = 255.255.255.255,
        Ascend-Assign-IP-Pool = 1,
        Ascend-Idle-Limit = 0

Which should work?  Anyway, when I try and start PPP, MS DUN (under Win95)
complains "Dial-Up Networking could not negotiate a compatible set of
network protocols" and I see that I'm being given address 0.0.0.0 by
PPP.

Normally I'd blame all this on DUN, but using a radius profile with a static
IP address in it on the same PC and it works happily.

Anything I'm doing wrong?  Can Radius run with Pool and Static entries?

Many thanks,
Aron
--
************** Aron Bibby                    Tel  : +44 (0)117 922 9604
****     ***** Hewlett Packard Laboratories  Fax  : +44 (0)117 922 9742
**  /_  __ *** Stoke Gifford                 Mobil: +44 (0)370 542  539
*  / / /_/  ** Filton Road
**    /    *** Stoke Gifford                 EMail:   aron_bibby@hp.com
****     ***** Bristol BS12 6QZ                      ab@hplb.hpl.hp.com
************** England                            aron@bibby.hpl.hp.com
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>