Re: (ASCEND) DSLPipe: No session with Frame Relay

["Jim Jones, Jr." <jimslists@arcomcontrols.com>]

Is the Frame Relay suposed to be faster?  I just put in something like this
with the speed set to 144000 using ppp and i only get about 80000...

I am using 7.10.5 as the folks at lucent said that anything earlier had a
severe problem with several things including NAT and Frame Relay.

Jim

----- Original Message -----
From: "Justin England" <jengland@enetis.net>
To: <ascend-users@bungi.com>
Sent: Sunday, April 02, 2000 1:11 AM
Subject: (ASCEND) DSLPipe: No session with Frame Relay


>
> I have two DSLpipe-HS connecting via dry-copper from the local telco, and
> the connection comes up fine at 1552000 (Only a few thousand feet away.)
> But it will never start an active session if I use Frame-Relay
> encapsulation.  I have used one of the cook-book examples from the manual,
> but nothing seems to work with Encaps=FR.  I can use PPP, but it seems to
> only give me about 56k throughput no matter what speed I use for the
> SDSL Line Rate.  I only see a couple of CRC's with over 10 million
> packets, so the line should be fine at that speed.   I am using software
> version 7.0.25 on both sides.
>
> Here is a snippet of my config:
>
> Configure...
> Rate Mode=singlebaud
> SDSL Line Rate=1552000
> Unit Type=CPE
> 20-000 Ethernet
> 20-100 Connections
> 20-101 DSLBridge
> Active=Yes
> Encaps=FR
> Bridge=Yes
> Encaps options...
> FR Prof=DSLframe
> DLCI=16
> 20-600 Frame Relay
> 20-601 DSLframe
> Active=Yes
> FR Type=DTE
>
> The COE side is the same except for:
>
> Unit Type=COE
> and
> FR Type=DCE
>
> First, what can I check to determine why the session will not start using
> Frame-Relay?  Second, why would Encaps=PPP limit my speed to around 56k
> (As reported by MRTG and FTP'ing large files accross the wan link)?  Last,
> what is the advantage of using which method of Encaps?
>
> Thanks for any input!
>
> Justin England jengland@enetis.net
> Network Administrator
> E-Net Information Services http://www.enetis.net
> Tel: 605-341-3638 Fax: 605-341-8880
>
>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>