Good idea. > Who can help me with a TFTP program to run under Win'95 because I only >have the normal ftp program. Or should I do this via the serial port and >use PCplus? Do it via the serial port using any terminal if you don't have any way to run tftp. Once you're connected and controlling the unit via a terminal: 1. Save your config. System-Sys Diag-Save Config. 2. Write down any passwords. They don't get saved this way. 3. Do Esc [ Esc - in quick succession to start the upload. 4. Send the file Xmodem. 5. After the upload completes, the unit restarts under the new load. 6. Do Esc [ Esc = in quick succession to get to Debug mode. 7. Type nvr to clear non-volatile RAM. The unit resets. 8. Load your config. System-Sys Diag-Upload Config. You might have to type q after it's done to regain control. 9. Reenter your password(s). 10. Reset the unit. System-Sys Diag-Sys Reset. Peter Lalor Infoasis plalor@infoasis.com <A HREF="http://www.infoasis.com/">http://www.infoasis.com/</A> 415-459-7991 x102 415-459-7992 fax ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg11804.html">(ASCEND) Re: NFAS?</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg11805.html">Re: (ASCEND) Pipeline75 dialing into USR I-Modem @ 128k</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg11799.html">(ASCEND) Visually impaired Authentication</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg11804.html">(ASCEND) Re: NFAS?</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="maillist.html#11806"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd282.html#11806"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>