Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) K56flex connect rate reporting?
At 09:26 AM 5/18/97 -0400, Robert A. Pickering Jr. wrote:
>On Wed, 14 May 1997, Kevin Smith wrote:
>
>> Well since it's still not currently possible to connect at 56000 (read FCC
>> limit), and you would only see up to 52000 on K56flex connects....*unless*
>> the information is set to 56000 for any K56flex connect....I'll check it
out
>> since in our LAB testing we were not running RADIUS (not part of the test
>> setup).
>
>Whoa! I read somewhere that K56Flex doesn't have the power limitations
>that X2 has. In fact, I'm communicating that fact. It was my understanding
>that the modem hardware had to be swapped out specifically because a
>software upgrade of the DSPs would then cause the same power problems as
>X2.
I would be interested to find out where you read/heard that, since the same
limitation exists in all implementations: X2, K56Plus, V.flex and K56Flex.
>The FCC limitation is on Power Output not on connect rates. It just so
>happens that for an X2 modem to connect above 53K they violate the FCC
>rule. However, again, I heard that K56Flex didn't have this limitation.
K56Flex has the same limitation.
Kevin Smith Updated Service and Support
Ascend Communications Resources are now at:
http://www.ascend.com/service
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.shore.net/~dreaming/ascend-faq>
or <ftp://ftp.shore.net/members/dreaming/ascend-faq.txt>
References: