Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) ether configuration
Eh? I'm taking it you have your ethernet card in slot 1 and wish to read
in the profile it would be done as follows:
admin> read ip-int {{1 15 5}}
IP-INTERFACE/{ { shelf-1 slot-15 5 } 0 } read
admin> list
interface-address* = { { shelf-1 slot-15 5 } 0 }
ip-address = 10.11.64.11/24
netmask = 255.255.255.0
proxy-mode = Off
rip-mode = routing-send-only
route-filter = ""
rip2-use-multicast = yes
ospf = { no 0.0.0.0 normal 10 40 5 simple ascend0 1 16777215 type-1
c0:00:00:00+
multicast-allowed = yes
multicast-rate-limit = 100
admin>
Of course if your's in in slot 1 then it would be
read ip-int {{1 1 1}}
I don't know if this answers your question, It probably would help
if you supplied the output of the show command
Jason Nealis
Director Internet Operations
Network Access
Erols Internet
On Thu, 9 Oct 1997, Gustavo Cruz Parra wrote:
> i have 2 days learning about MAX TNT
>
> i have problems with a ethernet configuration.
> when i do:
>
> tnt>read eth {1 1 1}
> tnt>list
>
> link-state=down
>
> how do i do for limk-state is up??
>
> help!
>
> Gustavo Cruz Parra
> g.cruz@ieee.org
>
>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: