Yes, if you have the right slot card. You need to set up a nailed PPP connection on the TNT. This is covered in the documentation. For a quick look of some of it you can check out "Configuring T1 Interface" - <A HREF="http://www.ascend.com/888.html">http://www.ascend.com/888.html</A> > On the Cisco side, I can specify an IP address for the serial interface, > but cannot figure out how to IP the WAN port on the TNT. I would recommend the documentation. Check out the "Listing the IP subprofile of a Connection profile" and "Example of a numbered interface WAN connection" where it discusses "ip-options remote-address" and "ip-options local-address". ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg10190.html">Re: (ASCEND) K56 boards rev. F</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg10188.html">Re: (ASCEND) User comment</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg10278.html">Re: (ASCEND) TNT T1 Termination</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg10154.html">(ASCEND) Hayes Optima 28'800 V.FC + MAX 4000</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="mail4.html#10189"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd220.html#10189"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>