Re: (ASCEND) Problems on a MAX 4000

[Sascha Pollok <sp@iphh.de>]

>>What happened? What should we do now?
>
>You might need to open the Max case and clear its flash memory
>and upload new code again... but you should probably call Ascend
>tech support for guidance.

:) I just got the Max out of the Rack and on my desk and startet it again.
It starts perfectly BUT with a configuration I fsave'd some weeks ago.
In case a similar fault occures again: how to clear the flashram? Was it the
Jumper for MAXHP somewhere in the faq? Or do I need pulling out the battery?

By the way: When moving from my crashed MAX to the secondary MAX I got a 8x
BRI Card out of the 1st one to get some Leased-Lines up again. On the
second Max I got a 6.1.7 running (without a running OSPF - although OSPF
debugging is broadcasting routes, the Cisco and the MAX don't talk). If I
try to store a tsave -am'ed config to my 1st (previously crashed) MAX, I
get several Errors like "Too nested menues" "--- Lost data ---" and some
seconds later a cancel due to errors. I never had problems of copying
configurations up/downgrade before. Maybe this is due to the missing BRI Card?
Do I have to configure the whole MAX again? <arghh>...

Kind regards,
     Sascha Pollok

---
 Sascha Pollok
 Technical Staff / Internet Port Hamburg
 Rödingsmarkt 14
 D-20459 Hamburg
 Germany
 Tel. +49 (0)40 37 49 190
 Fax  +49 (0)40 37 49 19-29
 Email: sp@iphh.de

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>