Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) P50
I have only one static route. The default route that points to my router.
Both maxes point to the same router. I heard something about an attribute
called ascend-if-address but when I tried that the p50 wouldn't route at
all. Any other suggestions.
East County Internet Services, Inc
-Jess-
CFO
System Admin
On Mon, 6 Oct 1997, Kevin Smith wrote:
> At 12:00 PM 10/4/97 -0700, Jesse Martinez wrote:
> >I have a user with a Pipeline 50. Not sure the rev of software he has. My
> >question is how do I set up radius to allow him to connect to either of
> >two maxes and route without problems. I gave him a subnet of 248 to use
> >and when he connect to the first max in a hunt group he's ok. If the call
> >hits the second max then he can't route. I've never configured a p50 so
> >I'm not sure of the settings on his side. Both maxes are in the same hunt
> >group.
>
> Whichever MAX picks up the RADIUS entry should start advertising the route to
> the P50 via a routing protocol (RIPv2 or OSPF). Do you have static routes
> setup that could be over-riding this ?
>
>
> Kevin
>
>
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups:
References: