Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) P50
You didn't mention if you are using a routing protocol here to handle the
dynamic updates that would be required to do this ?
At 07:51 PM 10/6/97 -0700, Jesse Martinez wrote:
>I have only one static route. The default route that points to my router.
>Both maxes point to the same router. I heard something about an attribute
>called ascend-if-address but when I tried that the p50 wouldn't route at
>all. Any other suggestions.
>
>
>East County Internet Services, Inc
>-Jess-
>CFO
>System Admin
>
>On Mon, 6 Oct 1997, Kevin Smith wrote:
>
>> At 12:00 PM 10/4/97 -0700, Jesse Martinez wrote:
>> >I have a user with a Pipeline 50. Not sure the rev of software he has. My
>> >question is how do I set up radius to allow him to connect to either of
>> >two maxes and route without problems. I gave him a subnet of 248 to use
>> >and when he connect to the first max in a hunt group he's ok. If the call
>> >hits the second max then he can't route. I've never configured a p50 so
>> >I'm not sure of the settings on his side. Both maxes are in the same hunt
>> >group.
>>
>> Whichever MAX picks up the RADIUS entry should start advertising the
route to
>> the P50 via a routing protocol (RIPv2 or OSPF). Do you have static routes
>> setup that could be over-riding this ?
>>
>>
>> Kevin
>>
>>
>> ++ Ascend Users Mailing List ++
>> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>>
>
>++ Ascend Users Mailing List ++
>To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd: <http://www.nealis.net/ascend/faq>
>
Kevin
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups:
References: