Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ASCEND) P50

I'm runing OSPF with rip turned off.


East County Internet Services, Inc
-Jess-
CFO
System Admin

On Mon, 6 Oct 1997, Kevin Smith wrote:

> You didn't mention if you are using a routing protocol here to handle the
> dynamic updates that would be required to do this ?
> 
> At 07:51 PM 10/6/97 -0700, Jesse Martinez wrote:
> >I have only one static route. The default route that points to my router.
> >Both maxes point to the same router. I heard something about an attribute
> >called ascend-if-address but when I tried that the p50 wouldn't route at
> >all. Any other suggestions.
> >
> >
> >East County Internet Services, Inc
> >-Jess-
> >CFO
> >System Admin
> >
> >On Mon, 6 Oct 1997, Kevin Smith wrote:
> >
> >> At 12:00 PM 10/4/97 -0700, Jesse Martinez wrote:
> >> >I have a user with a Pipeline 50. Not sure the rev of software he has. My
> >> >question is how do I set up radius to allow him to connect to either of
> >> >two maxes and route without problems. I gave him a subnet of 248 to use
> >> >and when he connect to the first max in a hunt group he's ok. If the call
> >> >hits the second max then he can't route. I've never configured a p50 so
> >> >I'm not sure of the settings on his side. Both maxes are in the same hunt
> >> >group.
> >> 
> >> Whichever MAX picks up the RADIUS entry should start advertising the
> route to
> >> the P50 via a routing protocol (RIPv2 or OSPF). Do you have static routes
> >> setup that could be over-riding this ?
> >> 
> >> 
> >> Kevin
> >> 
> >> 
> >> ++ Ascend Users Mailing List ++
> >> To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
> >> To get FAQ'd:	<http://www.nealis.net/ascend/faq>
> >> 
> >
> >++ Ascend Users Mailing List ++
> >To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
> >To get FAQ'd:	<http://www.nealis.net/ascend/faq>
> >
> 
> Kevin
> 
> 
> ++ Ascend Users Mailing List ++
> To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd:	<http://www.nealis.net/ascend/faq>
> 

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>
Follow-Ups: References: