Re: (ASCEND) Doing CLID with 7.0.0 (possible ?) [TNT also]

[Mike Jackson <mhjack@tscnet.com>]

On Sun, 29 Nov 1998, Bernhard Kroenung wrote:

> Hy
> 
> Did anyone manage to use CLID with 7.0.0 ? We're using May 1800 (BRI) and
> Max 2000 (E1) with fbik.m18/feik.m20 and noone of these could handle a
> call while Ethernet->Answer->Id Auth is set to Prefer/Fallback/Require etc.
> only when it is set to "Ignore".
> Ar there any other settings to change ? The only thing I see on an incoming
> call is a request via radius for the Number - a negative request and imme-
> diately a "Far End Hung Up" - if someone calls without a CLID it works (!)
> but via ISDN and via even a normal voice-call there is only a "Far End Hung Up".
> 

It looks like this is also broken on the Ascend Max TNT 7.0.0 software as
well.  I had to set answer:clid-auth-mode = ignore in order to even accept
calls on lines that were CLID capable.

					Mike Jackson
					TSCNet


++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>