Re: (ASCEND) DOV: 4048 call routing

[Joe Pautler <pautler@grasshopper.cit.buffalo.edu>]

DiGennaro wrote:
]
]It may not help now, but you also need to do the following:
]System -> Sys Config -> Sub-Adr=Routing

are you sure?  from what i can tell, Sub-Adr=Routing has to do with
using ISDN sub-addresses (specified in addition to the 7 digit phone
number).  we were just trying to do it based on routing the calls
via the DNIS info.  (by the way, i have since confirmed that our
PRI provider is definitely not providing us with DNIS info...so
that was defintely a/the problem).

for what it's worth, i did also try using the Sub-Adr=Routing in conjunction
with the Ans# parameters, and that didn't seem to work either....perhaps
the ISDN sub address stuff isn't being passed to us from our PRI
provider?


]> ]  we want to allow DOV (data over voice..tollmizer...etc)
]> ]  connections, in order to avoid ISDN data usage charges.
]> ]  however, as of now, a voice (tollmizer, etc) call results
]> ]  in a busy signal (presumably because the 4048 does not
]> ]  have anything to route the call to).  if i enable one
]> ]  of the modems, it will answer the call.  i currently
]> ]  have Ethernet -> Mod Config -> WAN Options -> Ans 1#=5601.
]> ]  changing that number to various other things (garbage)
]> ]  results in no change of the behavior of either voice
]> ]  or data calls.


___________________________________________________________________________
Joe Pautler, E.I.T.                             University at Buffalo
CIT/OSS Network Engineering                     224 Computing Center
http://www.oss.buffalo.edu/~pautler             (716) 645-3536

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>