Re: [TCLUG:2401] Setup help....

[Greg Garlough <garlough@bitstream.net>]

I had the same problem with cal 1.3. Try removing the aic7xxx.o.gz module right
before autoprobe then you will need to load an older module (rh 4.2 worked for
me) that you have copied to floppy.

"C. Justus Gibson" wrote:

> Hello T.C. Linux users...
>
> I am new to this mailing list and relatively new to linux. I currently have
> Linux loaded on a Dell Dimension 350 however I am having problems loading
> the Red Hat Linux 5.1 OS onto my Dell Dimension XPS 200 box.
>
> After the initial boot disk is loaded, the install CD is placed in the
> drive. After I select to load from CD it just sits at the message "Scanning
> SCSI bus...". It appears as if the system does not recognise my adaptec 2940
> Ultra Wide adaptor.
>
> Hitting Alt+F3 and Alt+F4 have provided me with the following messages...
>
> SCSI: aborting command due to timout: pid9, scsi0, channel0, id6, lun0
>
> <4>(scsi0:-1:-1:-1) Bad scbptr 16 during SELTO
> <4>(scsi0:-1:-1:-1) Referenced SCB 255 not valid during SELTO
> <4>             SCSISEQ = 0x5a SEQADDR = 0x7 SSTAT0 = 0x10 SSTAT1 = 0x8a
>
> Any help would be appreciated...thank you in advance for your time.
>
> -Justus
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: tclug-list-unsubscribe@listserv.real-time.com
> For additional commands, e-mail: tclug-list-help@listserv.real-time.com
> Try our website: http://tclug.real-time.com