Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) P50
Now we have at least 2 threads on this subject.....did we get routing table
info from the MAXen when this "failure" occurs ?
At 07:34 AM 10/7/97 -0700, Jesse Martinez wrote:
>I'm runing OSPF with rip turned off.
>
>
>East County Internet Services, Inc
>-Jess-
>CFO
>System Admin
>
>On Mon, 6 Oct 1997, Kevin Smith wrote:
>
>> You didn't mention if you are using a routing protocol here to handle the
>> dynamic updates that would be required to do this ?
>>
>> At 07:51 PM 10/6/97 -0700, Jesse Martinez wrote:
>> >I have only one static route. The default route that points to my router.
>> >Both maxes point to the same router. I heard something about an attribute
>> >called ascend-if-address but when I tried that the p50 wouldn't route at
>> >all. Any other suggestions.
>> >
>> >
>> >East County Internet Services, Inc
>> >-Jess-
>> >CFO
>> >System Admin
>> >
>> >On Mon, 6 Oct 1997, Kevin Smith wrote:
>> >
>> >> At 12:00 PM 10/4/97 -0700, Jesse Martinez wrote:
>> >> >I have a user with a Pipeline 50. Not sure the rev of software he
has. My
>> >> >question is how do I set up radius to allow him to connect to either of
>> >> >two maxes and route without problems. I gave him a subnet of 248 to use
>> >> >and when he connect to the first max in a hunt group he's ok. If the
call
>> >> >hits the second max then he can't route. I've never configured a p50 so
>> >> >I'm not sure of the settings on his side. Both maxes are in the same
hunt
>> >> >group.
>> >>
>> >> Whichever MAX picks up the RADIUS entry should start advertising the
>> route to
>> >> the P50 via a routing protocol (RIPv2 or OSPF). Do you have static
routes
>> >> setup that could be over-riding this ?
>> >>
>> >>
>> >> Kevin
>> >>
>> >>
>> >> ++ Ascend Users Mailing List ++
>> >> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>> >> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>> >>
>> >
>> >++ Ascend Users Mailing List ++
>> >To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>> >To get FAQ'd: <http://www.nealis.net/ascend/faq>
>> >
>>
>> Kevin
>>
>>
>> ++ Ascend Users Mailing List ++
>> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>> To get FAQ'd: <http://www.nealis.net/ascend/faq>
>>
>
>++ Ascend Users Mailing List ++
>To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
>To get FAQ'd: <http://www.nealis.net/ascend/faq>
>
Kevin
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups:
References: